Видео

thanks

Bar element analysis in Femap. super useful for beginners.

Highly useful Femap bar tutorial. Very helpful to run stiffeners offset from plate to do quick buckling runs. thanks a lot.

How you do this in the CFD post . please help

You are my hero

Thanks❤

wow!

Epic

ughhh it was so simple i totally failed my math exam

Great video, very informative. Is this model available for download anywhere?

I have been using FeMap with Nx Natran with the Solid coming from the Solid Edge Fabrication model Assembly and Stress Linearization within Femap. This is more of an ASME approach.

very helpful and extremely well explained, thank you!!!!

THANK YOU

Thank you

Hi, I have tried the exact same method for extending the the nozzle to touch the cylinder and create the surface but it is not working. Can you suggest another method?

Thanks for this tutorial! It looks that the rotating pole is increasing in diameter when rotating from side to side. Does it have something to do with RBE2 definition?

thank you king

This video saved me thank you

Would removing the fillets affect the results of a modal analysis? How can you account for fillets with a midsurface?

Hi I am quite new with FEMAP, as you said FEMAP is unit less so how can I know that the force apply is in Newton?

What are the units for the results, sir? MPa, Kgf or others..

infact all the values are different

your enthalpy values are not the same as the ones on the steam table

You should say do commentary problem what is the problem in it?

I interpolate and vg at 124 centigrade is .794362 is it correct?

mi servirebbe un modello di un serbatoio di un aereo, ma non riesco a trovare tutorial su come crearlo

thank you!

This problem is from which book

Hi ! 1:45 - According to formula for Ccr=SQRT(4*m*k) the damping ratio should be equal to 20, but not 10

You have any idea why Ive got continous displacement on similar analysis?

but it says its one half the original so didnt volume increased? im so confused nec i found one solution that did with increased volume and one with decreased volume whichis the correct one?

thank you for this video..

it is awesome!!!! tks for soving this question it helps me a lot<3

Hi, Thanks for this nice video, your videos are very informative. Keep it up. I have one comment on your calculation of "C". I think you have missed 4 under square root. with that, your C will be 1 and not 0,05. correct me if I am wrong.

Thank you so much!

Can you please explain how do you consider the constraints for pin and roller support?

Any channel that helps me pass fuckin thermodynamics gets a sub from me. Great content and quick too.

Thanks for the video, it helped me through tough times in life. I always come to this video when i need reflectance in life, where friends and family can't help. Thermaldynamics just makes me take my mind off of lifes problems. Love, Sweden.

how to explode

tack kingen

nice and clear explained

Very good introduction to program. Thank you! :)

great video !!!

good useful video. liked and subbed. i am trying to find normal modes of a steel tube. is there anything different that i need to do in the setup.

Very nice video. You can also use the multiset animation option to see the full response in the animation.

thank you so much!!

Thank you so much. Great support

I think it's wrong

How would the graphic look on the R134A letter?